Tennsco Shelving 48 WIDE Letter Size 128848 - Manual (Page 3)

14. If you are assembling only a single unit,
assembly is now complete (shown below left).
If you are assembling multiple units joined
together, your starter unit should have been
assembled with a “T” upright (shown below
right), as described in step two. Continue with
step 15.
Completed
Single Unit
Completed Unit
Ready for Add-On
16. If installing units back to back, insert
clothespins (Ref. No. 7) through top of
uprights to tie units together.
15. Repeat steps 7
through 11, add-
ing a new "L" or
"T" upright and
connecting with
shelf supports to
complete the
add-on unit.
13. Insert shelf dividers
(Ref. No. 6), five
per shelf (or as
needed), by placing
dividers into slots on
shelf and then hooking into
the slot in the back stop.
12. The top shelf supports and
top shelf (Ref. No. 2) should be
installed flush
with the
upright top.
Note that the
top shelf has
no divider slots.
11. Continue the assembly by
placing supports, shelves
and backstops as described
in steps 8 through 10. The
recommended spacing be-
tween shelves is
twelve inches,
which equals six
open keyhole slots
between supports.
PLEASE NOTE: The plain
shelf (without slots) is for
the unit TOP.
10. Insert a back stop (Ref. No. 5) into the third
keyhole slot above
the shelf. Make sure
that all rivets
are firmly
seated in
the keyhole
slots, as
described in step 6.
Round Hole
goes toward
front of unit.
Square Hole
goes toward
rear of unit.
9. Place a slotted shelf (Ref. No. 3) over supports.
IMPORTANT: Be sure that square hole in end of
shelf flange is to the rear of the unit. If shelf is
reversed, the dividers will not
fit in their slots.