Triton 96XX CASH DISPENSER CABINET Installation Manual - Manual (Page 3)

96XX CASH DISPENSER CABINET INSTALLATION GUIDE
TRITON SYSTEMS, INC. 3
5. Stand the unit up and walk it out of the shipping carton.
6. Remove the wrapping from the Cash Dispenser.
7. Use the silver-colored key to unlock both the Control Panel
and the Fascia door (which conceals the locking mechanism)
on the front of the cabinet. Open the Fascia door.
8. Turn the handle on the locking mechanism to open the front
enclosure door. If the door is locked see the sidebar on this
page for help in unlocking the combination lock.
9. Remove the accessory kit from inside the bottom enclosure;
open and inspect the contents. Check the contents against
the enclosed packing list. Report any missing parts to Triton
Systems immediately.
MARK/DRILL MOUNTING HOLES
CONCRETE STRENGTH
The floor at the installation location should consist of com-
mercial-grade concrete, measuring at least 2000 psi in com-
pression strength.
The full effectiveness of the mounting
anchors depends upon meeting this specification! Check
with the contractor/builder or owner of the installation to verify
that this requirement can be satisfied.
LEVEL FLOORING REQUIREMENT
It is very important that the Cash Dispenser cabinet
be located on flat, level flooring! If the floor is not
flat and level the cabinet bottom and/or walls may
become distorted when the mounting bolts are tight-
ened down! This could prevent the security vault
door from closing!
UNLOCKING
COMBINATION
LOCKS
MECHANICAL LOCK. There are
two marks on the dial ring. The in-
dex mark at the top of the dial is
used for opening the lock. A revo-
lution is counted each time the se-
lected number is aligned with the
opening index.
Locks are shipped on a factory set-
ting of ‘50’. To unlock, turn the dial
to the left (counterclockwise) FOUR
turns, stopping on ‘50’. Then, turn
the dial to the right (clockwise) until
the bolt is retracted.
ELECTRONIC LOCK. Upon arrival,
the combination of the lock should
already be preset to 1-2-3-4-5-6. To
unlock, enter the preset
combination and check for proper
operation. After each keypress, the
lock will beep. After the final digit
has been entered, the lock will beep
twice, and the open period will
begin. When a valid combination
has been entered, the operator wil
have approximately 3 seconds to
open the lock. To open the lock, turn
the dial clockwise. After the lock is
opened, the door latch may be
turned and the safe opened.