Triton RT2000 X2 Installation Manual - Manual (Page 23)

23
M
ODEL
RT2000 (X2) I
NSTALLATION
G
UIDE
S
EALING THE
C
ONTROL
P
ANEL
T
RIM
To ensure that the temperature around the unit is maintained during cold weather, it’s important that the wall
RSHQLQJ LV SUHSDUHG FRUUHFWO\ $Q\ FDYLW\ LQ WKH ZDOO VKRXOG EH VHDOHG WR SURYLGH D ÀXVK VXUIDFH 7KH JDS
between the ATM and the inside wall opening should be left clear to allow air to circulate at room tempera-
ture. After the control panel trim is installed, a good weather seal is needed between the exterior wall
and the trim. A suitable water -resistant sealant product is required around the periphery of the control
panel trim. There are also products that are color tinted to closely match the trim color.
**IMPORTANT**
S
EAL THE TRIM TO THE EXTERIOR WALL WITH A WATER
-
RESISTANT SEALANT TO
PREVENT WATER INTRUSION
. DO NOT
SEAL AROUND THE BOTTOM OF THE TRIM
!
S
MALL DRAIN HOLES ARE LOCATED ON THE UNDERSIDE THAT MUST BE CLEAR
!
Control panel trim sealed.
'UDLQ KROH ORFDWLRQV