Triton RL5000XP PC-BASED ATMS Installation Manual - Manual (Page 41)

41
P
OWER aND
C
OMMUNICaTION
Figure 3. Install snap bushing on
access hole that carries power and
phone cords. Install dome plug on
unused access hole.
Figure 2b. Power and phone cords
routed through side access hole.
POWER SUPPLY CORD
SPECIFICATIONS
For European applications, the
power supply cord must conform to
the following specifications:
1. Two-conductor with Physical
Earth (PE) ground.
2. IEC 320 molded connector on
one end and molded plug on the
other end.
3. Certified for country of
installation.
4. Rated minimum H05VV-F with
minimum 0.75 mm2 (except
where specific countries require
1.0 mm2) conductors.
5. Maximum length: 3 meters.
* IMPORTANT *
Power Outlet Accessibility
Whether you are installing a new
outlet, or plan to use an existing
outlet to supply power to the ATM,
make sure the following require-
ments are met:
1. The outlet is located near the
cabinet.
2. The outlet is easily accessible.
3. Access to the outlet will not
be blocked once the cabinet
is installed!