U.S. Sunlight 9930TR Solar Powered Attic Fan User Manual

Solar powered, Installation and mounting guide, Installation instructions

Advertising
background image

Installation and Mounting Guide

Florida Building Product Approval (# FL 14561) and Texas Department of Insurance (TDI) Approval
Use all 8 flashing screws included in package to comply with severe weather building codes.
Compatible with Solar Controller™ for after dark operation. Go to www.ussunlight.com for further details.

Thank you for purchasing the Solar Powered Attic Fan from U.S. Sunlight Corp. We are committed to providing alternative

energy products that can improve your everyday life and our environment. We have reduced packaging material and

eliminated Styrofoam to reduce the impact on landfills.

Installation video is available to view online at www.ussunlight.com.

If there is a problem with your U.S. Sunlight product call us at 1-877-50-USSUN

Spare parts, installation advice, or recommendations for professional installers in your area are only a phone call away.

Professional installation may be much less than you expect, please call us to get average rates for your area.

Please note that this product is designed for asphalt shingles, wood shake, or flat tile roofs with a minimum of 4/12 pitch.

If you have spanish tile, s-tile, concrete, metal or flat roof, please call us before attempting to install the product.

Before beginning the installation of your new Solar Powered Attic Fan, please read through the entire installation

instructions and call us if you have any questions.

TOOLS REQUIRED

• Ladder
• Reciprocating saw or jig saw
• Power drill with a 1/2” – 1” inch drill bit
(only one needed)
• 1 – 2” deck screw and screw bit
• Hammer & roofing nails or self taping
galvanized screws

• Caulk Gun with Waterproof Roofing Sealant
• Measuring tape or ruler
• Permanent marker, sidewalk chalk or crayon
• Roofing knife or box cutter
• Flat pry bar

Installation Instructions

It is suggested that you prepare the opening prior to bringing the fan up on the roof.

Always secure the fan on the roof to avoid injury or having the fan slide off the roof and get damaged.

Step 1 - Ventilation

To maximize the solar fan’s effectiveness you should remove or block any rooftop static vents or ridge

vents. If there is an existing turbine type vent, simply remove the old vent and use the same hole for

the new installation, or block completely. (fig. 1) Make sure you have proper intake ventilation at the

eave or fascia. Use a ratio of 1 sq. ft. of intake ventilation for every 600 sq. ft. of attic space.

Important Tip:

To properly close off any static vents, use tar paper and staples
as shown in

(fig. 2 & 3).

fig. 2

fig. 3

Tel: 877-50-USSUN
www.ussunlight.com
[email protected]

SOLAR POWERED

fig. 1

Block or

Remove

© Copyright 2012 U.S. Sunlight Corp SolarAtticFan SmoothAirC01 ver 4

Instrucciones en español disponible en www.ussunlight.com

Advertising