Universal Air Tools UT8750B - 5 Disc (125mm) - Manual (Page 4)

Accessories
moving.
19) A grinding wheel should only be fitted by a competent person
trained to do so. The wheel must be of the correct size and speed
rating.
20) Check the speed of the grinder at least once per week, if it is in
regular use, with an accurate tachometer.
21) The tool must only be used with the grinding wheels as set out in
section “Foreseen Use of the Tool” and shown on parts list. Never fit
any other device.
22) Carry out the instructions as set out in “Putting into Service”.
23) Many countries have local or national rules re the use and fitting of
grinding wheels. Make sure such rules are observed.
24) Use a barrier to prevent sparks causing a hazard to the operator,
any other person or anything within the vicinity of the sparks.
25) If a wheel guard becomes damaged or has withstood a wheel
breakage, the guard must be changed.
26) Do not use chipped or cracked grinding wheels.
27) Always wear impact resistant eye protection.
28) Use only the disc plates, Items (4) and (5) provided with the grinder
for locating and clamping the wheel. Never use substitutes. Use the
paper blotter fixed to the wheel as this ensures even tightness when
the wheel is secured.
29) Tighten the wheel plates sufficiently to prevent wheel spin off when
the grinder is turned off. Do not tighten excessively as this may crack
the wheel.
30) The noise from the tool or the process noise of the grinding
operation may be such that hearing protection should be worn.
31) Avoid inhaling dust from the grinding process. Wearing of a
breathing mask is recommended. Grinder certain materials may mean
that special breathing precautions are necessary. Seek advice before
using the tool.
32) Always ensure that the workpiece is firmly supported so that it
cannot move during the grinding process.
33) If the grinder is dropped do not use unless the wheel is first
checked for damage by a competent person.
34) When not in use the grinder should be stored in a safe place where
it will not be damaged. If a tool has not been used for a period of time
check the tool as for the first time of using.
35) Be aware that if the grinding process causes high vibration, special
precautions should be taken.
36) The operator should be aware that the grinding wheel will continue
to rotate after the power supply has been shut off. This could cause a
hazard.
37) Always store grinding wheels in accordance with the
manufacturer’s instructions.
38) Check frequently that the spindle thread has not become
damaged or worn.
39) Always ensure that the grinding wheel has a higher permissible
running speed to the speed of the grinder.
Distributor
Notes
Page No 4
Declaration of Conformity
Universal Air Tool Company Limited
Unit 8, Lane End Industrial Park, High Wycombe, Bucks, HP14 3BY, England
declare under our sole responsibility that the product
Models UT8750, UT8750A, UT8750B Angle Disc Grinder, Serial Number
to which this declaration relates is in conformity with the following standard(s) or other normative document(s)
EN792 (Draft), EN292 Parts 1 & 2, ISO 8662 Parts 1 & 4, Pneurop PN8NTC1
following the provisions of
89/392/EEC as amended by 91/368/EEC & 93/44/EEC Directives
Place and date of issue Name and signature or equivalent marking of authorised person
Lane End D.H.Moppett (Man. Director)
This document may not be copied wholly or in part by anyone without the consent of the Directors of Universal Air Tool Company Limited
©Copyright of Universal Air Tool Company Limited, established in the United Kingdom, 1994
Designed & Written in the U.K.