Universal Air Tools UT8955 - Manual

Manufacturer/Supplier Product Type
RPM
Cycles Per Min
Tel No Fax No
(01494) 883300 (01494) 883237
Model No/Nos Serial No
Product Nett Weight Recommended Use Of
Balancer Or Support
Recommended Hose Bore
Size - Minimum
Recommended Max.
Hose Length
Ins M/M Ft M
Foreseen Use
These screwdrivers are designed for the tightening and
loosening of threaded fasteners within the range as specified by
the manufacturer. They should only be used in conjunction with
1/4" male hex shank screwdriver bits and fastener drivers.
Do not use the tool for any other purpose than that specified
without consulting the manufacturer or his authorised
representative.
Putting Into Service
Air Supply
Use a clean lubricated air supply that will give a measured air
pressure at the tool of 90 p.s.i./6.3 bar when the tool is running
with the trigger fully depressed. Use recommended hose size
and length. It is recommended that the tool is connected to the
air supply as shown in figure 1. Do not connect the tool to the
air line system without incorporating an easy to reach and
operate air shut off valve. The air supply should be lubricated. It
is strongly recommended that an air filter, regulator, lubricator
(FRL) is used as shown in Figure 1 as this will supply clean,
lubricated air at the correct pressure to the tool. Details of such
equipment can be obtained from your supplier. If such
equipment is not used then the tool should be lubricated by
shutting off the air supply to the tool, depressurising the line by
pressing the trigger on the tool. Disconnect the air line and pour
Work Stations
The tool should only be used as a hand held, hand operated
tool. It is always recommended that the tool is used when
standing on a solid floor. It can be used in other positions, but
before any such use the operator must be in a secure position
having a firm grip and footing. The operator must adopt a firm
grip sufficient to resist the torque reaction of the tool, i.e. the
tool will try to turn in the hand.
The operator must also be
aware that when loosening
fasteners, the tool can move
quite quickly away from the
fastener being undone. An al-
lowance must be made for
this rearward movement to
avoid hand entrapment. The
operator must also make al-
lowance that if the tool does
turn in the hand, the hand is
not trapped against any rigid
object.
No
Page No 1
Straight Reversible
Screwdriver
UT8955
3/8 10 30 10
1600
Includes - Foreseen Use, Work Stations, Putting Into Service,
Operating, Dismantling, Assembly and Safety Rules
Operator Instructions Important
Read these instructions carefully before installing, operating,
servicing or repairing this tool. Keep these instructions in a safe
accessible place.
Universal Air Tool Company Limited
Unit 8
Lane End Industrial Park
High Wycombe
Bucks
HP14 3BY
lbs
Kg 2.42
1.1
Noise Level Sound Pressure Level 83.0 dB(A)
Test Method Tested in accordance with Pneurop
test code PN8NTC1 and ISO Standard 3744
Vibration Level
Test Method Tested in accordance with ISO
standards 8662 Parts1 & 7
11.8 Metres / Sec²
Personal Safety Equipment
Use - Safety Glasses
Yes
Use - Safety Gloves
Use - Safety Boots
Use - Breathing Masks
Use - Ear Protectors
Air Pressure
Recommended Working
6.3
bar
90
PSI
Recommended Minimum
n/a
bar
n/a
PSI
Maximum
7.0
bar
100
PSI