Universal Air Tools UT8355-RL - Manual (Page 4)

Technical Specification
Air Inlet 3/8 - 18 NPTF
Clutch Pin Type
Overall Length
(Std Anvil)
260 mm (9.7")
Width 85 mm (3.17")
Operation Torque
300 to 800 lbf-ft
41.5 to 110.5 Kgf - m
Air Consumption @ 90 PSIG
Free Running Avg 5.8 cfm (42 SCFM)
On Load Avg 3.9 cfm (28 SCFM)
unexpected movement of the tool.
6) Use only correct spare parts for repair.
7) Always ensure that the reverse valve is in the correct position
before operating the tool. Do not run the tool unless the socket
is first located on the joint.
8) Check hose and fittings regularly for wear. Use quick connect
couplings only as recommended. See "Putting into Service". Do
not carry the tool by the hose and ensure that the hand is away
from the on/off valve when carrying.
9) Do not attempt to hold or guide the socket by hand when the
tool is running.
10) Do not exceed maximum recommended air pressure.
11) Use safety equipment as recommended.
12) The tool is not electrically insulated. Do not use where there
is a possibility of coming into contact with live electricity.
13) Preferably shut off the air supply before changing sockets or
at least ensure that the hands are well clear of the operating
trigger.
14) Take care against entanglement of moving parts of the tool
with clothing, ties, hair, cleaning rags, etc.
15) When loosening fasteners first ensure that there is sufficient
clearance behind the tool to avoid hand entrapment. The tool
will move away from the threaded joint as the nut/bolt etc. is
loosened and rides up the thread moving the tool with it.
16) Only use extensions, adaptors and universal joints suitable
for use with impact wrenches.
17) If the tool appears to malfunction remove from use
immediately and arrange for service and repair.
Distributor
Notes
Page No 4
Accessories
Declaration of Conformity
Universal Air Tool Company Limited
Unit 8, Lane End Industrial Park, High Wycombe, Bucks, HP14 3BY, England
declare under our sole responsibility that the product
Models UT8355-R & UT8355-RL 3/4 Impact Wrenches, Serial Number
to which this declaration relates is in conformity with the following standard(s) or other normative document(s)
EN792 (Draft), EN292 Parts 1 & 2, ISO 8662 Parts 1 & 7, Pneurop PN8NTC1
following the provisions of
89/392/EEC as amended by 91/368/EEC & 93/44/EEC Directives
Place and date of issue Name and signature or equivalent marking of authorised person
Lane End D.H.Moppett (Man. Director)
This document may not be copied wholly or in part by anyone without the consent of the Directors of Universal Air Tool Company Limited
©Copyright of Universal Air Tool Company Limited, established in the United Kingdom, 1994
Designed & Written in the U.K.