Et-312 – USGlobalsat ET-312 User Manual
Page 17
ET-312
The Specifications are subject to be changed without notice. Copyright © 2007, GlobalSat Technology.
Page 17 of 21
Version 1.4
<Parity> 0=None,Odd=1,Even=2
Example: Set DGPS Port to be 9600,8,N,1
＄PSRF102,9600,8,1.0*12
D). Query/Rate Control ID:103 Query standard NMEA message and/or set output rate
This command is used to control the output of standard NMEA message GGA, GLL, GSA,
GSV
RMC, VTG. Using this command message, standard NMEA message may be polled once,
or setup for periodic output. Checksums may also be enabled or disabled depending
on the needs of the receiving program. NMEA message settings are saved in battery
backed memory for each entry when the message is accepted.
Format:
＄PSRF103,<msg>,<mode>,<rate>,<cksumEnable>*CKSUM<CR><LF>
<msg> 0=GGA,1=GLL,2=GSA,3=GSV,4=RMC,5=VTG
<mode> 0=SetRate,1=Query
<rate> Output every <rate>seconds, off=0,max=255
<cksumEnable> 0=disable Checksum,1=Enable checksum for specified
message
Example 1: Query the GGA message with checksum enabled