Vapamore MR-75 Amico - Manual (Page 5)

FILLING & OPERATION
Fig.1
!
or
GO TO VAPAMORE.COM TO SEE THE MR-75 AMICO INSTRUCTIONAL VIDEO
GENERAL FUNCTION: The MR-75 Amico steamer uses a heated boiler tank filled with water
to create steam. When first plugged in you will see the red power light showing that the
unit is powered on and heating. Once at full temperature the light will turn green showing
the steamer is ready for use. This light will change back and forth from red to green during
use as the heater cycles on and off. The steamer can be used anytime after the initial
heating and when the light is cycling between colors. The steam pressure will fluctuate
as the steamer is being used and the boiler cycles on and off during use.
Using additives of any kind will void the warranty.
! Only fill with distilled water. Using “hard” mineral heavy water will clog
.
internal components and can cause failure to internal parts and void the warranty.
Fig.2
!
300ml / .32qt
Push down
and turn.
Plug in the steamer to a grounded 110 outlet. The steamer
is ready for use. (Initial start up from cold machine is aprox.
4 min) *The status light will cycle red to green during use
as the boiler maintains the temperature. Fig. 3
Vapamore
!
!
!
7 7
1
5
Fig.3
Red light when
plugged in.
Green light when
ready for use.
NOTE:
If steamer is hot, allow
Unscrew the tank cap by pressing the cap down and
simultaneously turning counter clockwise. Fig. 1
Use the supplied measuring cup filled with distilled water
to the 200ml MAX line. Fig. 2
Replace the water tank cap by pressing down on the cap
and simultaneously turning it clockwise. Make sure the
cap is fully tight to prevent any steam from leaking out.
and once cooled down tighten cap further.
Always make sure the steamer is not plugged in and
is cool before filling with water.
steamer to cool down completely before removing water
tank cap.