Vapamore MR-1000 Forza - Manual (Page 4)

GETTING STARTED
Vapamore
if over pressure or over temperature is detected.
!
!
!
!
GO TO VAPAMORE.COM TO SEE THE MR-1000 FORZA INSTRUCTIONAL VIDEO
WHEEL INSTALLATION
Install the rear wheels using the supplied tools along
with the supplied wheel bolt, washers, and lock nut.
The wheel bolt is inserted into the wheel followed by a
washer then inserted into the steamer wheel mount.
Once inserted, install the other washer and the lock nut.
Tighten lock nut. (Fig.1)
Wheel bolt
Lock bolt
Once unpacked the only items that need to be installed are the rear wheels, the storage
basket, and the rear handles. All the necessary tools and hardware are included to
install these items.
Fig.1
BASKET & HANDLES
Fig.2
Bolt Bolt
Cord
reel
Cord
reel
CORD REEL
The basket and handles are secured to the main steamer
body using 6 of the supplied Allen head style screws.
(*Note: there are extra Allen head screws provided).
Align the basket and handle screw hole locations and
insert the Allen head screws loosely until all screws are
in place. Once all screws are in place Secure all screws
firmly with the supplied Allen tool. (Fig.2)
The cord reel hooks rotate by pulling outward from the steamer then twisting to rotate.
Use this rotate function to easily remove the power cord and to position the hooks for
cord storage. Use the Velcro cord strap to secure the cord during transport. (Fig.2)
Washer
Forza
Always ensure the steamer is on a level floor or flat surface when in
!
At first start up and when refilling the cold water tank when empty you will
hear the pump fill the boiler from the cold water tank. Once the pump is running hold
the steam gun trigger down for 15-20 seconds to release the air trapped in the boiler.
!
operation. Do not tip or tilt the steam cleaner during use.