Video Mount Products PM-LPB User Manual
Page 3
Step 1
Before starting, lay out all parts to your mount and match them to the
parts list provided. Verify that you have all your parts before attempt-
ing to assemble the mount.
Step 2
Attach the feet or to the projector using the appropriate
screws or .
Step 3
Attach the feet or to the legs using the wing screws
Note: If you plan to feed the cables through the holes in the cen-
ter of the mount itself take the time to do so now before proceeding
further. Note: If using the longer feet use the M6 screws in
the rear holes of the feet in addition to the wing screws to better
secure the longer foot.
If you are using the fl ush mount plate:
Step 4
Attach the ceiling plate to the top of the upper plate using
the short socket head screws and washers .
Step 5
Mark the ceiling or desired mounting surface in preparation of instal-
lation of ceiling plate . If mounting to wooden ceiling joists, pre drill
pilot holes using a 7/32” drill bit. Attach the ceiling plate to the
wooden ceiling joist using the 5/16” by 2.5” long lag screw and
washer . Proceed to step 10. WARNING: Please verify that your
mounting surface will support the combined weight of your mount,
mounting hardware, and fl at panel. Also verify that the mounting
surface is safe to drill through. Please note only mounting hardware
for mounting to wooden ceiling joists will be provided with the unit.
If mounting to a surface other than wooden ceiling joists then other
hardware will be required. If in doubt or uncertain about any of the
above, please contact a professional installer.
If you are using the ceiling plate:
Step 6
Attach the feed through coupler to the ceiling plate using
the longer socket screws , washers and nylon nuts .
Step 2: Attaching the feet to
the projector
Step 3: Attaching the feet to
the mount
Step 4: Attaching the mount
to the ceiling plate
Step 5: Attaching the
ceiling plate to the ceiling
15
1
3
15
12
13
2
14
1
7
4
16
Step 6: Attaching the feed
through couple to the ceiling
plate
22
23
12
13
11
16
13
24
1
1
27
26