Video Mount Products PM-LPMB - Manual (Page 3)

Step 1
Before starting, lay out all parts to your mount and match them to
the parts list provided. Verify that you have all your parts before
attempting to assemble the mount.
Step 2
Attach the feet or to the projector using the appropriate
screws or .
Step 3
Attach the feet or to the legs using the wing screws
. Note: If you plan to feed the cables through the holes in
the center of the mount itself take the time to do so now before
proceeding further. Note: If using the longer feet use the
M6 screws in the rear holes of the feet in addition to the wing
screws to better secure the longer foot.
If you are using the ceiling plate (#19) otherwise proceed to step 5.
Step 4
Mark the ceiling or desired mounting surface in preparation of in-
stallation of the ceiling plate . Pre-drill, if necessary, and mount
the ceiling plate to the desired surface. WARNING: Please ver-
ify that your mounting surface can support the combined weight of
your mount, mounting hardware and projector. Also verify that the
mounting surface is safe to drill through. If in doubt, please contact
a professional installer.
Step 5
Attach the 1.5” NPT pipe to the pipe couple . Tighten the brake
screw into the pipe to secure in place. If you use the ceiling
plate provided, secure the other end of the 1.5” NPT pipe into
the ceiling plate by tightening the second brake screw in
the other end of the pipe.
Please verify that all nuts and screws are securely tightened.
Step 2: Attaching the feet to
the projector
Step 3: Attaching the feet to
the mount
WARNING: The installer of these products must verify that the mount
surface, ceiling or wall, will safely support the combined weight of
all attached equipment and hardware. Video Mount Products will
not be held liable for the improper use or installation of its products.
Enjoy Your Mount!
Step 5: Attaching the mount
to the 1.5” NPT pipe
1
8 9
7
14
Step 4: Attaching the ceiling
plate to the mounting surface
13
10
8 9
9
10
15
19
19
19
12
12 19