Video Mount Products TR-60 - Manual (Page 5)

Step 5
Level out the tripod and secure the front foot ( TR-36 and
TR-60) of the tripod using a pitch pad ( TR-36 / TR-60)
underneath the feet and lag screws ( TR-36 and TR-60) to se-
cure the feet to the roof surface. WARNING: To insure a secure
installation make sure that the lag screws are secured into a
rafter or trust section or some other solid piece of wood. If none
are available, then have a person place a large section of 1.5”
thick wood on the underside of the locations where the lags are
going to come through to provide stable mounting platform for
the lags to attach to. Once the lags are through the mounting
surface, coat the lag screws with roofi ng tar or some other suit-
able sealant to prevent leaks.
Step 6
For the TR-36
Secure the antenna mast in the top ring of a TR-36 ( TR-36)
using the M8 screws ( TR-36) and either the hex nut or square
nuts ( or TR-36). Repeat the process for the bottom ring
( TR-36 and TR-60) if you did not use the L bracket ( TR-36).
For the TR-60
Secure the antenna mast in the top ring of a TR-60 ( TR-60)
using the M8 screws ( TR-60) and a hex nut on either side
of the ring ( TR-60). Repeat the process for the bottom ring
( TR-60) if you did not use the L bracket ( TR-60) or lower
plate ( TR-60).
Please verify that all nuts and screws are tight.
Step 5: Securing the front foot
Step 6: Securing the mast in
the tripod
WARNING: The installer must verify the installation meets all
applicable codes and survival requirements. Video Mount
Products will not be held liable for the improper use or instal-
lation of its products.
Enjoy Your Mount!
16
4
17
6
15
10
11
5
20
4
21
22
4
4 18
10