Video Mount Products PRM-2 - Manual (Page 4)

Step 5
Attach the satellite dish footplate to the mount plate using
the correct size hex head screw ( or ), lock washer ( or
) and nut ( or ).
Step 6
Attach the mount plate to the middle most rails A at the
desired proximity to the pivot point using the 5/16” hex head
screw , lock washer and nut .
Step 7
Place assembly on the peak of the roof. Load ballast (weight
placed into the sled to weigh down the non-penetrating roof
mount) into the front and rear wells as required for the applica-
tion. Note: It is the installer’s responsibility to verify the correct
amount of ballast for the given application. Verify that all nut
and screws are completely and securely tightened. Roof mats
can be purchased to protect the roof surface is so desired/
required. It is important that the underlying roof structure be
strong enough to resist whatever forces that may be subjected
to it from the satellite dish system and mount. For extreme wind
conditions it is recommend the mount be tethered with cable.
It is up to the installer to verify that the installation meets all ap-
plicable codes and standards. Video Mount Products does not
accept and responsibility for verifying that the PRM-2 will work
for any given installation.
Step 5: Attaching the satellite
footplate to the mount plate
Step 6: Attaching the mount
plate to the front wells
WARNING: The customer must verify the installation meets all
applicable codes and survival requirements. Video Mount
Products will not be held liable for the improper use or instal-
lation of its products.
Enjoy Your Mount!
10
5
7
1
5
8
9
Step 7: Placing the assembly on
the roof and loading the ballast
11 12
7 8 9