Video Mount Products BR-4XD - Manual (Page 2)

Step 1
Before starting, lay out all parts to your mount and match them to
the parts list provided. Verify that you have all your parts before
attempting to assemble the mount. Note: It is highly recommend-
ed that the installation of the mount be done by a professional.
Step 2
Mark the wall or desired mounting surface in preparation of in-
stallation of the main support. Pre-drill if necessary and mount the
main support to desired surface. Note: Place the other support as
far away from the fi rst support as possible to give the antenna mast
more stability.
Warning: Please verify that your mounting surface will support the
combined weight of your mount, mounting hardware, and antenna
mast. Also verify that the mounting surface is safe to drill through.
If in doubt, please contact a professional installer.
Step 3
Place the antenna mast into the cup on the main support. Place
clamp plate on the opposite side of the antenna mast and use
the carriage screw and hex nuts to tighten down the clamp plate
onto the antenna mast clamping it in place.
Please verify that all nuts and screws are securely tightened.
Step 2: Attaching the main
support to the mounting
surface
Step 3: Attaching the antenna
mast to the main supports
WARNING: The installer must verify the installation meets all applicable codes and survival require-
ments. Video Mount Products will not be held liable for the improper use or installation of its products.
Enjoy Your Mount!