Video Mount Products SM-1 - Manual (Page 3)

Step 1
Before starting, lay out all parts to your mount and match them to
the parts list provided. Verify that you have all your parts before
attempting to assemble the mount. Note: It is highly recommend-
ed that the installation of the mount be done by a professional.
Step 2
Attach the mounting plate to the desired position on the siding
and secure in place using the M4 countersink lag screw.
Step 3
Take the base plate of the satellite dish and match the holes in the
plate to the holes in the four corners of the mounting plate. Mark
holes in preparation of installation of the base plate and use the
2.5” long lag screws and washers to secure the base plate to the
mounting surface. Note: It is crucial to make sure the lags screws
are secure into something solid behind the siding of the house.
The siding alone WILL NOT support the combine weight of the dish
and mount.
Warning: Please verify that your mounting surface will support the
combined weight of your mount, mounting hardware, and dish.
Also verify that the mounting surface is safe to drill through. If in
doubt, please contact a professional installer.
Step 4
Attach the remainder of the satellite dish to the satellite dish base
using the hardware provided with the satellite dish.
Please verify that all nuts and screws are securely tightened.
Step 2: Attaching the
mounting plate
Step 3: Securing the base
plate to the mounting surface
WARNING: The installer of these products must verify that the
mounting surface, ceiling or wall, will safely support the com-
bined weight of all attached equipment and hardware. Video
Mount Products will not be held liable for the improper use or
installation of its products.
Enjoy Your Mount!
Step 4: Attaching the rest of the
satellite dish