Video Mount Products DVR-WA - Manual (Page 3)

Step 1
Before starting, lay out all parts to your mount and match them to
the parts list provided. Verify that you have all your parts before
attempting to assemble the mount.
Step 2
The DVR-WA is designed to have a mounting hole pattern that
is centered on 16”. Take the left arm and mark the mounting
surface with the mounting hole locations. Using the mounting hole
you already have drawn mark the next set level with the fi rst 16” to
the left or the right of the fi rst set of holes. If mounting to wooden
studs, pre drill pilot holes using a 7/32” drill bit. Mount the left arm
to the right most set of holes using the hex lag screws and
mount the right arm to the left most set of holes also using the
hex lag screws . WARNING: Please verify that your mounting
surface will support the combined weight of your mount, mounting
hardware, and DVR. Also verify that the mounting surface is safe
to drill through. Please note only mounting hardware for mount-
ing to wooden studs will be provided with the unit. If mounting to
a surface other than wooden studs then other hardware will be
required. If in doubt or uncertain about any of the above, please
contact a professional installer.
Step 3
Place the DVR-LB1 or DVR-LB2 onto the left and right arms.
Match the largest holes in the bottom of the lockbox starting with
the rear to the threaded holes in the left and right arms. Use
the screws and washers to attach the rear most holes on the
lockboxes to the rear most holes on both arms. Then attach the
front most holes on the lockboxes to the front most holes on both
arms again using the screws and washers . Note: You may
have to pull the arms into alignment with the holes.
Please verify that all nuts and screws are securely tightened.
Step 2: Attaching the left and
right arms to the mounting
surface
Step 3: Place the DVR-LB1 or
DVR-LB2 on arms
WARNING: The installer of these products must verify that the mount surface, ceiling or wall, will safely
support the combined weight of all attached equipment and hardware. Video Mount Products will not
be held liable for the improper use or installation of its products.
Enjoy Your Mount!
5
1
1
5
2
1 2
1 2
3 4
3 4