Enjoy your mount – Video Mount Products LCD-PV User Manual
Page 5
Step 11
Screw in the 1.5” NPT pipe into the top of the female pipe couple
(#37)
and the ceiling plate
(#42)
. Screw ¼” brake screws
(#36)
into
the top of the female pipe couple
(#37)
and ceiling plate
(#42)
so
the brake screws are tight against the pipe. This will help prevent the
pipe from turning out of the pipe couples.
Step 12
If you desire to use the camera bracket then follow this step, other-
wise proceed to the next step. First determine if you wish the camera
to be mounted below or to the side of the monitor. Then determine
how long the camera arm needs to be to extend past the side or
bottom of the monitor. Use the connectors provided
(#25
,
#26
&
#32)
to extend the L connector
(#24)
as needed. Take the end as-
sembly
(#27
,
#28
,
#29
,
#30
&
#31)
and screw it to the connector
(#24
,
#25
,
#26
or
#32)
furthest from the center of the mount. Make
sure the M6 brake screws
(#31)
are tight in the swivel metal
(#29)
.
Step 13
Attach your monitor to the chosen mounting plate
(#5
or
#6)
using
the M4
(#21)
, M5
(#22)
or M6
(#33)
screws as appropriate.
Please verify that all nuts and screws are securely tightened.
Step 11 : Inserting the 1.5” NPT
(monitor not shown for clarity)
Step 12: Using the camera
bracket
WARNING: The installer of these products must verify that the mount surface, ceiling or wall, will safely
support the combined weight of all attached equipment and hardware. Video Mount Products will not
be held liable for the improper use or installation of its products.
Enjoy Your Mount!
37
33
5
6
42
21
22
36
37
42
25
26
32
24
27
28
29
30
31
31
29
25
26
32
24