Vitrex EAR PROTECTION - Manual (Page 2)

APPLICATION:
The Ear Cap is hearing protector with a foldable headband and reusable, replaceable earplugs. It can be worn over-the-head,
behind-the-head or under-the-chin. Weight including headband: 10g.
STANDARD NUMBER:
Tested according to EN352-2: 1993
Subjective attenuation according to ISO 4869 – 1: 1990. Institute: BIA, Germany.
Test report No. 9606892. Notified body No. 0121 – BIA, Germany
INSTRUCTIONS FOR USE:
1. Unfold the headband
2. Place the hearing protector in the desired position. Holding the headband by its ends, insert the plug with a slight
rocking and twisting motion, while pulling the outer ear upwards and backwards to straighten the ear canal.
3. In the presence of background noise (below 80 dB), check that the plug attenuates noise well without any leakage.
4. Wear the plugs during the entire noise exposure.
MAINTENANCE:
The earplugs should be regularly inspected for serviceability.
CLEANING:
After use, clean the plugs with mild soap and warm water.
STORAGE:
The plugs should be stored before and after usage in a way that protects them from dirt, grease, etc.
WARNINGS:
This product may be adversely affected by certain chemical substances. Please note that the protection afforded by the
earplugs can be severely impaired, of the above recommendations are not followed.
CORDED AND TAPERED EAR PLUGS
INSTRUCTIONS FOR USE:
1. With clean hands, roll the plug between your fingers into a very tight cylinder and insert it with a slight rocking and
twisting motion while pulling the outer ear upwards and backwards to straighten the ear canal.
2. Let the plug expand in the ear canal for approx. 30 seconds. In the presence of background noise (below 80 dB),
check that the plug attenuates noise well without any leakage.
3. Choose the right size plugs for a proper fit. If neither of the two sizes fits, please choose another type of Vitrex
hearing protector before entering the noise area.
4. Wear the plugs during the entire noise exposure.
STANDARD NUMBER:
Tested according to EN352-2: 1993
Subjective attenuation according to EN24869– 1: 1993 Institute.
Notified body No.0121 – BIA, Germany Certificate No. 941057
MAINTENANCE:
The ear plugs should be regularly inspected for serviceability.
STORAGE:
The plugs should be stored before and between usage in a way that protects them from dirt, grease, etc.
WARNINGS: