Vitrex BRUTUS750 - Manual (Page 3)

4 | CLINKER-XL www.vitrex.co.uk | 5
Fig 5
When the tile is in position, score the tile by exerting
continuous downward pressure on the push bar along
the entire length of the tile. After scoring a clear,
continuous line along the tile, ensure the tile remains
locked in position on the shock absorbing trays.
Fig 6
Put the breaking foot in position as indicated in Image
6. Generally, if the tile thickness is less than 10mm,
then use the small breaking foot. If the tile thickness
is more than 10mm, then use the big breaking foot.
Fig 7 & 8
When using the small breaking foot, gradually
increase downward pressure until the tile is cut
Fig 9 & 10
When using the small breaking foot, gradually
increase downward pressure until the tile is cut
hOw TO USE
Remove any dirt or residue from the carriage bar
Note: Do not use any lubrication
Fig 11&12
Replace the cutting wheel if it is worn
Fig 13
Tighten the carriage lever, as indicated
Fig 14
Gradually tighten the carriage, as indicated
Fig 15
Tighten the rigid rail, as indicated
MaINTENaNCE
Fig 6
Fig 12
Fig 5 Fig 11
Fig 8
Fig 10
Fig 7
Fig 9
Fig 14 Fig 15
Fig 13
CLINKERXL-XL-MANUAL-A5-2011.indd 4-5 16/12/2011 12:33