Vitrex WSPP600IND - Manual (Page 2)

02 03
Tel: +44 (0) 1253 789180 Tel: +44 (0) 1253 789180
Owner’s Safety and Operating Manual
Contents
Safety Instructions ..................................................3
Machine Specification & Electrical Requirements .....4
Assembly & Operating Instructions ......................5-6
Maintenance & Warranty ........................................7
Safety Instructions
When using the machine, always observe
the enclosed safety instructions as well as
the additional safety instructions.
Denotes risk of personal injury or damage
to the tool.
Take measures to protect your eyes.
Take measures to protect hearing.
Do not use toothed cutting discs.
Consult the manual.
Additional Safety Instructions
for Tile Cutters
• Make sure that the cutting disc is
correctly screened by the guard.
• Do not use cutting discs which are bent,
deformed or otherwise damaged.
• Do not use cutting discs which do not
comply with the specifications stated in
this manual.
• Never start cutting tiles before the
machine reaches full speed.
•Never attempt to cut extremely small
workpieces.
•Do not leave the work area until the
machine has been switched off and the
cutting disc has come to a complete
stand-still.
• Never attempt to stop the cutting disc by
exerting pressure on the side of the disc.
• Before use check the pump for damage.
Should the pump be damaged, it must
not be used.
• Never let the pump run dry.
• Never lift the pump by the mains cable or
hose, but only by the housing.
• Always unplug the machine before
performing any maintenance.
• Do not use the machine before it has
been completely assembled and
installed according to the instructions.
• Do not perform any design, assembly or
construction activities on the table while
the machine is switched on.
• Unplug the machine and clean the table
before leaving the work area.
Electrical Safety
Always check that the power supply corre-
sponds to the voltage on the rating plate.
Conditions of the
Tile Cutter (FIG.A, FIG.B)
The tile cutter can work in conditions of FIG.A
and FIG.B either on the stand provided or
placed in a work area.
Description (FIG. C)
Your tile cutter has been designed for cutting
ceramic and clay paving and wall tiles.
1 - Leg1
2 - Leg2
3 - Brace
4 - Small work table
5 - Water pump
6 - On/off switch
7 - Motor
8 - Ruler
9 - Big work table
10 - Cooling water reservoir
11 - PRCD plug
Mounting the Frame (FIG. D)
• Hold the brace (3) in place at one side.
• Mount the first Leg2 (2) into the hole of
brace (3)
• Mount the others according to the same in-
structions to the brace (3).
• Mount the first long Leg1 (1) into the hole of
Leg2 (2)
• Mount the others according to the same in-
structions to the Leg2 (2).
Power Pro 600 Tile Cutter
Power Pro 600 Tile Cutter