Wellsaw 1348 - Manual (Page 11)

9
Maintenance
Caution: Disconnect the electrical supply and press
emergency STOP button before performing any
maintenance. DO NOT service the Frame Hydraulic
Cylinder or Down Feed Valve unless the frame is in
the DOWN position or resting on a mechanical stop,
such as a block of wood.
Daily
1. Keep the saw clean and free of chips.
2. Maintain the coolant level and keep the coolant
tank and filter clean of chip accumulation or sludge.
Monthly
1. Check, adjust and replace blade brush as needed.
2. Lubricate drive gears
3. Inspect carbide guides and bearings.
4. Inspect drive belt.
5. Clean coolant tank and filter as needed.
Annually
1. Check hydraulic oil level.
2. Replace guide rollers and carbide inserts.
3. Inspect gear box. Lubricate as needed.
thoroughly removed before lubricating the saw. The
following lubrication recommendations cover usual saw
applications. Heavy use and hostile environments may
indicate more frequent lubrication for best saw
performance.
Vise Screw, Ring Gear, Drive Pinion
1. Inspect Monthly.
2. Use Anti-Seize on Vise Screw.
3. Use Extreme Pressure Open Gear Lube sparingly on
Ring Gear and Drive Pinion
Gear Case
1. Inspect after 3 years (6,000 hours).
2. Use Mobilgrease XHP 220 or equivalent.
3. Viscosity: Heavy Grease, drop point 550EF
4. Military Specification: None
Hydraulic Cylinder
1. Inspect annually. Fill to top of plug. Drain and
replace every 5 years (10,000 hours).
2. Fill with Mobil Velocite Oil #6 or equivalent.
3. Viscosity at 100EF: SUS 57-61.
4. Military Specification: None.
M o t o r
Lubrication
Correct and adequate lubrication is a very important
factor in determining the life and service of your
Wellsaw. It is essential that all dust, dirt, chips,
etc. be
1. Inspect annually. Re-lubricate every 2 years (4,000
hours) 1 to 2 full strokes.
2. Use Shell Dolium R or equivalent.
3. Viscosity: Heavy Grease, drop point 219EC.
4. Military Specification: None.
Parts Ordering
For your convenience:
When contacting your Wellsaw supplier or the Company for parts or service, it is essential that you
have your saw Model, Serial Number and Purchase Date available.
Jot them down here for handy reference.
Model:
Serial Number:
Purchase Date: