WEN 6018 6 inch Vortex Variable Speed Dual Action Polisher - Manual (Page 7)

7
INSTALLING THE SIDE HANDLE
A side handle is included with your polisher for easy tool handling and to help maximize tool control during opera-
tion. The gear housing design allows for mounting of the side handle on either side of the D-handle.
To install the side handle, unscrew the D-handle bolt on the side where you want to put the side handle. Screw the
handle securely into the threaded hole on the D-handle where the bolt used to be.
CHANGING THE CARBON BRUSHES
1) Remove the housing of the polisher by unscrewing the three screws on the back right-hand side of the polisher’s
body. Find the two carbon brushes under a clip at the top of either side of the polisher with a copper wire running
from them. (Figure A)
2) Remove the small clip holding the carbon brush in place (Figure B)
3) Slide the carbon brush out of the casing. Unclip the copper wire from the mount on the opposing end of the
carbon brush (Figure C). It may be fairly tight and take a little force.
4) Replace the carbon brush with the new carbon brush. Slide the copper wire’s clamp back onto the casing. This
may require something to help push the clamp into place if too tight. Slide the carbon brush’s body back into its
housing. Replace the clip.
5) Repeat for the carbon brush on the opposite side of the polisher if necessary.
ASSEMBLY AND ADJUSTMENTS
FIGURE A FIGURE B
FIGURE C