WEN 56660 9 AMP Snow Shovel manual - Manual (Page 8)

8
ASSEMBLY
Upper handle assembly
1. Firmly insert the Pipe into the Handle (Figure 1); making sure tab is inserted into locking
hole. (Figure 2)
2. Pipe is fully inserted and ready to be tightened using the Handle Knob fastener. (Figure 3)
3. Insert the Handle Knob fastener and tighten by turning
clockwise. (Figure 4)
Lower handle assembly (Figure 5, 6 & 7)
1. Put Pipe Bushing onto the Pipe (Figure 5).
2. Locate the tube notch track and align it with the notch
slot at the opening of the main thrower unit (Figure 6).
Insert pole into the opening.
3. Secure the tube to the main thrower unit using 2 bolts and nuts (Figure 7).
Positioning the assist handle (Figure 8)
1. Move and rotate the assist handle to a position that is comfortable for
you.
2. Tighten the knob.
Adjusting the snow shovel height (Figure 9)
1. Loose the knob.
2. Set the tube to a height that is comfortable for you by sliding the upper
handle to your desired height.
3. Tighten the knob.