WEN 22020 2 Gallon Oil Free Air Compressor - Manual (Page 8)

common sense and caution are factors which cannot be built into this product, but must be
supplied by the operator.
Assembly Instructions
CAUTION! Always make sure the Compressor’s Power Switch (45) is in its “OFF” position
prior to performing any service, maintenance, or cleaning of the Compressor.
1. Handle is shipped partially attached. Remove screw (46) and position handle as shown in
figure A. Re-install screw (46) and tighten securely.
2. Install air-flow valve in pressure regulator (24). Note: Use sealing tape or silicon thread
compound on air-flow valve threads to prevent air leaking. Connect the ¼” female
connector to the air-flow valve. Remember to use the sealing tape.
HOSE CONNECTION
1. Attach an air hose to the compressor’s air outlet (air-flow valve) with the ¼” female
connector already attached. Connect the air hose to the air inlet of the tool. Use sealing tape
for best air tight connections.
Operating Instructions
To Start The Compressor:
1. Check to make sure the Air Tank’s Drain Valve (54), located at the bottom of the Air Tank
(53), is fully closed. Pull on the Safety Valve (25) to verify that it is not stuck. (See Figure B
and C)
8