WEN 3500 Generator Parts Instructions - Manual

Wen 3500 Generator Section
Locate the vented cover to the left of the Muffler and remove the two screws holding the cover
in place. The screws are either 7mm or 10mm, depending on the model.
Under the cover you will see the main components of the generator circuit. The Voltage
Regulator is a rectangular box held in place with two 7mm screws.
The Brush Assembly is at the top with two individual wires attached to it.
The Brush assembly is held in position with one 7mm screw.
The Wiring Bus connects the Stator to the Control Panel on the front.