Work Sharp WS3000 Tool Bar Attachment - Manual (Page 10)

Roughing Gouge
(11) Multi Jig Tormek® SVS-50 with Roughing Gouge
Use Vee Plate fixture when sharpening
Roughing Gouges
See Roughing Gouge Set Up Chart
(Section 10) for preset grind angles.
Or set the TSO and H to match the existing angle.
Record on the Data Chart in section 7.
Technique:
Roll the tool from one side to the other on the Tool Bar in a
smooth, steady motion. This will create a consistent grind
pattern and provide the sharpest, most consistent cutting
edge.
Do not start grinding in the center of the tool. Begin at one
side and smoothly roll the tool to the other edge. Check
edge for grind pattern and sharpening progress after every
other pass.