American Weigh Scales AMW-250i - Manual (Page 3)

I. Operation
1. Place the scale on a level surface and press the “ON/OFF” switch to
turn on the scale.
2. Wait until the LCD display shows “0” before adding items to be
weighed.
3. Gently apply all item(s) to be weighed onto the weighing platform.
4. You can press the “Kg/Lb” button to switch between kg / g and lb /
oz.
II. Tare Weighing.
1. Turn on scale as described above.
2. Place the container or tare item onto the platform.
3. Press TARE and wait until [0.0] is displayed.
4. Add the “net-weight-item”.
Note: When all weight is removed from the scale, the tared value of a
container will be displayed as a negative value. Press the tare button
again to return scale to zero.
III. Memory / Add Weigh
This scale has an “Add Weigh” function.
1. Place an item to be weighed on the tray
2. Press “TARE”, thedisplay will reset to “0.0”
3. Place another item onto the scale and press “TARE” again
4. The combined weight of the two items will be displayed. You may
repeat this process for up to 12 items.
IV. Hold Function
To use the “HOLD” function.
1. Turn the scale ON
2. Place the item(s) on the scale.
3. Press the “HOLD” button. The symbol “HOLD” will show on the
display.
4. The scale will beep once the weight has been stored in memory.
5. The weight will be displayed on the LCD for 5 seconds even after
removing the item(s) from the weighing platform.
6. To clear the HOLD value, press the “HOLD” button again.