American Weigh Scales Blade-150 - Manual (Page 4)

IV. Basic Calibration:
•
Turn on the scale.
•
Press and hold the MODE button until the LCD displays “CAL”, then
release the MODE button.
•
Press the MODE button again and the LCD will flash”CAL” then
“100.00” will flash 3 times gently place the 100g calibration weight on
the platform.
•
Wait 3-4 seconds, the LCD will display “PASS” and then “100.00”
•
Remove the weight and turn off the scale, calibration is complete.
V. Advanced Calibration: If the LCD displays “OUE2” when you
turn on the scale, calibrate as follows:
•
Turn the scale on.
•
Before the scale completes its power up sequence you must press
the MODE and TARE buttones at the same time and hold them down.
If this step is successfully completed then the LCD will display “CAL”
and then a random number. If you do not get the random number, try
again.
•
Wait for the random number to stabilize.
•
Press the MODE button again, the LCD will display “2ero” and then
another random number; place the 100g calibration weight on the
platform.
•
Wait 3-4 seconds then press MODE again, the LCD will display
“PASS” and then “100.00”.
•
Remove the weight and turn off the scale, calibration is complete.