American Weigh Scales Blade-V2-400 - Manual (Page 3)

I. OPERATION
Place Scale on a horizontal flat surface.
1. Press the [ ] key.
2. Wait until "0.0” is displayed.
3. Put the object(s) on the weighing platform.
4. Using the [
M
] key, you can switch between the
weighing units.
II. TARE WEIGHING
1. Turn on scale as described above.
2. Place the "tare item" on the platform.
3. Press [ T ] and wait until "0.0" is displayed.
4. Add the "net-weight-item".
III. CALIBRATION
Calibration is NOT required before first use. Only
calibrate if scale is not weighing properly.
**Make sure you use the correct calibration weight for
your scale or the calibration will not be accurate**
BLADE-v2-50: 50g calibration weight
BLADE-v2-100: 100g calibration weight
BLADE-v2-400: 200g calibration weight
1. Turn OFF the scale.
2. Press the [ ] key, then quickly press and hold
the [
M
] key until "CAL" is displayed. You may now
release the [
M
] key.
3. Press [
M
] again. The display will show "CAL"
followed by the required calibration weight (see
above).
4. Place the required calibration weight onto the center