American Weigh Scales CD-1000 - Manual (Page 3)

II. TARE WEIGHING:
1. Turn on scale as described above.
2. Place the “tare item” on the platform.
3. Press [T] and wait until “0.0” is displayed.
4. Add the “net-weight-item”.
III. COUNTING FUNCTION:
1. Turn on the scale and wait until the LCD displays “0.0”.
2. Place a sample amount (25pcs, 50pcs, 75pcs or 100pcs) of the
quantity you wish to weigh and count onto the platform.
3. Press and HOLD [C] key for 2 seconds, the LCD will display “25”.
4. Press [M] key to select the sample amount of the item that you have
put onto the platform.
5. Press [C] key to confirm the above information, the LCD will now
display “pcs” in the corner, to show that the scale is in counting mode.
6. Remove the sample quantity from the platform.
7. You now can place any amount of your item(s) on the scale and the
LCD will display a count.
8. You can switch between weighing mode or counting mode by press-
ing [M] or [C] key respectively.
IV. CALIBRATION: (use 500g for CD-500, use 1000g for CD-1000)
Calibration only needs to be performed if scale is not weighing properly.
1. Turn the scale on and wait for “0.0” to be displayed then press and
hold the [M] key for 3 seconds.
2. Release the [M] key.