American Weigh Scales Mini CD-50 - Manual (Page 3)

I. OPERATION:
1. Place scale on a horizontal flat surface, press [I/O]
2. Wait until “0.0” is displayed.
3. Put the object(s) on the weighing platform.
4. Using the [M] key, you can switch between the weighing units.
II. TARE WEIGHING:
1. Turn on scale as described above.
2. Place the “tare item” on the platform.
3. Press [T] and wait until “0.0” is displayed.
4. Add the “net-weight-item”.
III. CALIBRATION
Only perform calibration if there is a problem.
1. Turn on the scale by pressing the [I/O] key.
2. Wait for the scale to go to zero first, then press and hold the
[M] key until the display shows “CAL” then release it.
3. Press the [M] key again and the display will show “CAL” then
the required calibration weight will be displayed.
5. At this point, place the required calibration weight on the scale.
After a few seconds the display will show “PASS” then the weight
will display again.
6. Calibration is complete! You can now remove the weight and
turn off the scale.