Step 3 attach the back brace and bottom shelf, Step 4 table top preparation – Catskill Craftsmen 2007 User Manual
Page 7
STEP 3
ATTACH THE BACK BRACE AND
BOTTOM SHELF
A. The Top Back Brace attaches 1 1/4” down on
the legs, allowing clearance for the hinges and
drop leaf supports. Attach the back brace with
bastions to the right and left side assembly.
STEP 4
TABLE TOP PREPARATION
A. Invert table top on smooth, flat surface. Attach the 4 L-Brackets with 5/8” #6 screws, using the
round hole as shown in Illustration 4B.
B. Attach the 3 hinges with 5/8” #8 screws. Attach drop leaf supports with 5/8” #8 screws as shown in
illustration 4A.
Illustration 4C
Make sure the round
hole is used to attach
the L-Bracket to the
bottom of the table top
Illustration 4B
Illustration 4A
You must use the smaller hole, furthest
from the edge for L-bracket attachment,
as shown in illustration 4C.
B. Attach the bottom shelf to the inside of
all four legs using the 1 1/4” #8 screws.