Catskill Craftsmen 1527 - Manual (Page 9)

STEP 9
Attach handle/towel bar to side panel with 1 1/4” #8 screws from inside side
panel.
1 1/4” Phillips Flat Head #8 Screw (14)
2 Used in this step
STEP 10
A. Tap/insert ONE 1 1/2” pin
into each end of both doors.
DON’T OVERDRIVE PINS!
Pins should stick up about
1/2” when seated.
B. Attach the doorspacer to
the left door with 5/8” #8
screws. The spacer has a
space at the top to allow
magnet clearance and is
almost flush with the bottom
of the door. Countersunk
holes out.
C. Attach the magnet plate
(may be stuck to magnet! )
with the 1/2” #4 screw to
the top of the right door.
Bumps go toward the wood.
D. Attach door handles with
1” truss head machine
screws.
1 1/2” Long 3/16” DIA. Steel Pin (4)
4 used in
this step
5/8” Phillips Flat Head #8 Screw (3)
3 used in this step
ILLUSTRATION 9
Magnet Plate (1)
1” Truss Head Machine Screw (6)
2 used
in this step
1/2” Phillips Flat Head #4 Screw (1)
1 used in this step
ILLUSTRATION 10
2 Used
in this step
3/16” Flat Washer (4)