Catskill Craftsmen 14485 - Manual (Page 11)

Illustration 8C
Drawer Front
D. Insert
the B-Nuts into the
nut access holes on the inside
of the Drawer Sides with the threaded
end facing out. Take the Drawer Front and
carefully insert the Posts into the ends of the Brace
Sides, through the sides of the B-Nut until seated.
Push Nut snugly against the wood in the nut
access hole toward the Drawer Front. Hole should
be slightly off-center toward the Drawer Front.
Insert the Set Screw and tighten down. The Drawer
Sides should be tight against the Drawer Front.
Illustration 8D
C. Take two (2) Bastion Posts, align the threaded ends of the
Posts with the post holes located near the ends of the inside
Drawer Front. Tighten Posts down until the solid shaft of the
Post hits the wood. Back Post out until the hole/screwdriver slot
in the end of the Post is parallel and in direct line with the long
edges of the Drawer Front.
E. Attach the Drawer Glides (left and Right) to the
Drawer Sides using two 7/16” #6 Pan Head
Screws per glide. Open end of glide goes toward
the back of the drawer. DO NOT INSERT
DRAWER INTO CABINET AT THIS TIME.
Illustration 8E
10