Catskill Craftsmen 51533 - Manual (Page 6)

STEP 5
A. Turn the side/back
assembly upside down
(invert) on top of the
inverted table top.
4 Used in this step
1” Long 3/16” DIA. Steel Pin
PIN
PIN
5/8” Phillips Head #7 Screw
4 Used in this step
STEP 6
Attach Tower Bar to Side Panel
Attach the handle/towel bar to the
side panel with 1” #8 screws/washers
from inside cabinet.
3/16” Flat Washer
2 used in
this step
3/16” Flat Washer
1” Phillips Flat Head #8 Screw
2 used
in this step
B. Using the X marks as a guide, insert the tips
of the 5/8” #7 screws into the pilot holes through
“L” bracket hole in the unit top and finger tighten.
When all 4 screws are properly aligned, tighten
down.
D. Tap two 1” pins into EACH side panel. These
pins will hold the bottom shelf as illustrated.
Bottom Front Brace
STEP 7
Tap Pins Into Brace Ends
Take the 2 front braces and tap/insert one 3/4”
steel pin into each end of both braces until seated.
About 3/8” will stick out when seated. Ok if loose.
4 used in this step
3/4” Long 3/16” DIA. Steel Pin
3/4” Pin
Top Front Brace
Insert