Catskill Craftsmen 51537 - Manual (Page 7)

5/8” #5
STEP 5
A. Attach the drawer back to the drawer sides with four
1 1/4” #8 screws. Make sure parts are aligned
as in illustration 6A.
B. Insert drawer bottom into the slots in the drawer
sides, best side to inside of drawer. Slide down until
seated in the slot in the drawer back. See illustration 6B.
C. Screw the cam posts into the two outside holes on
the inside face of the drawer front until seated. Only
3/8” of the post goes into the wood, leaving the 4 larger
guide rings/head exposed. See illustration 6C. Visit us
at www.catskillcraftsmen.com to view our cam video.
D. Insert the posts into holes in the drawer sides until
seated against the front end of the drawer sides. Insert
cams so that slot in the cam fits over the post and turn
with Phillips screwdriver until seated. Don’t over-torque!
See illustration 6D. See our video online at
www.catskillcraftsmen.com
E. Attach drawer handle with two 7/8” Truss Head
screws each. (no illustration).
F. Attach drawer glides to drawer sides using
5/8” #5 screws. See illustration 6E
ILLUSTRATION 6C
Below line in wood
Cam Posts (2)
4 used
in this step
1 1/4” Phillips Flat Head #8 Screw
2 used
in this step
7/8” Truss Head Machine Screw
2 used
in this step
Cam
4 used
in this step
5/8” Phillips Flat Head #5 Screw
ILLUSTRATION 6A
ILLUSTRATION 6B
ILLUSTRATION 6D
ILLUSTRATION 6E