Catskill Craftsmen 54238 - Manual (Page 10)

STEP 9
A. Stick magnet to magnet plate on a door.
B. With all other doors open, close the
door. The magnet should be positioned
over the wooden block on the bottom of the
top front brace. Hold the magnet in place
with your thumb, and open the door. The
magnet will be in the correct position on
the block.
C. Secure magnet with the two pan head
screws in the magnet packet. Center
screws in the slot in the magnet . This will
allow adjustment later, if needed.
D. Repeat these steps for all the doors.
No pilot holes as softwood.
5/8” Pan Head Screws
STEP 10
A. Lay the cart on it’s back. Insert and tap caster sockets with hammer until the teeth grab the wood.
DON’T POUND SOCKET FLAT OR CASTER SHAFT WILL NOT ENTER.
B. Insert casters and seat by pushing straight
downward with heel of your hand, or tap into
place with a hammer. Don’t be afraid to give
them a good downward whack on the solid
metal part of the caster!
C. Locking wheels usually go on front.