COSA Xentaur Xentaur XPDM - Manual (Page 21)

page 18
Appendix B: Flow Diagram of User Interface in the Set-Up State
Legend: / separates alternatively displayed messages
Buttons without designator or arrow leading out, perform no function
Hi/Lo
SET
SET
SET
Lo
Lo
Hi
SET
SET
value ˚C
SET
SET
SET
{
sensor type
{
changes by 0.01 db
{
changes by 0.1˚C
{
changes by 0.1˚C
{
changes by 0.1˚C
{
units
Un-
Loc
Loc
Hi Lo Mid
Test Analog Output by forcing it to high and low end or midpoint.
(E. G. if DB9 connector pin 9 is grounded, Hi =20mA, Lo=4mA, Mid=12mA)
Set measured attenuation at a known low dewpoint
Set low dewpoint for above attenuation
Manual calibration
Set dewpoint corresponding to low end of analog output
Factory default is low range of sensor, e. g. -100˚C for XTR-100
Factory default is high range of sensor, e. g. +20˚C for XTR-100
Factory default is locked
Set dewpoint corresponding to high end of analog output
Lock or unlock the unit.
When locked, unit parameters can not be changed
blank ˚F ˚C ppm LBS G/m3 PSI % ˚C˚F Temp˚F Temp˚C
Choose alternate units to show when displaying dewpoint.
Choose sensor type
XTR-100 XTR-65
measure
attenuation of
sensor
& Power ON initialization
and sign on message For backlight, hold
until it comes on
Factory default is blank, (there is no alternate display).
These are set properly at factory with shipped sensor. Do not modify these settings, unless you are changing the sensor.
value ˚C
˚C