Edwards Signaling 125XBRi Chameleon - Manual (Page 4)

P/N 3101611 ISSUE 3
Wiring (Refer to Figures 3 and 4)
AC models
1. There are four 18" wire leads: white (neutral), red
(for activation of red LEDs), blue with green stripe (for
activation or green or blue LEDs--depending on model)
and amber (for activation of amber LEDs).
Using wire nuts, connect white lead to AC neutral and
connect each of the other three leads to AC hots.
DC models
1. There are four 18" wire leads: black (negative), red
(for activation of red LEDs), blue with green stripe (for
activation of green or blue LEDs--depending on model)
and amber (for activation of amber LEDs).
Using wire nuts, connect black lead to DC negative and
connect each of the other three leads to DC positives.
2. Turn on power and verify that the signal operates
properly.
Maintenance
Cleaning
The module lens exterior surfaces should be periodically
cleaned with a soft clean cloth using water and a mild deter-
gent to maintain optimum light visibility. Disconnect power
before cleaning.
Lens Replacement
1. Remove (4) screws securing the lens to the base from
bottom of base and remove lens.
2. Replace lens on base and secure with (4) screws
removed in step 1 (Figure 2).
Table 3. Replacement Parts
GRAY BASE BLACK BASE
Catalog Number Catalog Number Replacement Lens Replacement Lamp
125XBRiRBA24D 125XBRiRBA24DB
125LC The 148,000 hour** lamp is
permanently installed. 125XBRiRGA24D 125XBRiRGA24DB
125XBRiRBA120A 125XBRiRBA120AB
125LC
The 148,000 hour** lamp is
permanently installed.
125XBRiRGA120A 125XBRiRGA120AB
*Median LED Life (L70) based on manufacturer's projections. Refer to http://www.philipslumileds.com/pdfs/WP15.pdf.