Contact information – Edwards Signaling HPSA15 Series User Manual
Page 2
Advertising
2 / 2
P/N 3101246 • REV 02 • REB 15FEB13
Figure 2: Mounting dimensions
To conform with UL requirements, wires must be connected as shown in wiring diagram (see Figure 3).
Note: The maximum wire size that can be connected to this device is 18 Gauge.
Figure 3: Wiring diagram
Caution: Do not loop wires under screw terminals. Break wire run to provide supervision of connection. Installation must comply
with all Building Codes and NFPA guidelines. Installation must adhere to N.E.C. and NFPA 70/72 wiring directives and comply with
all National and Local Building Codes.
Contact information
For contact information, see www.edwardssignaling.com
Advertising
This manual is related to the following products: