Edwards Signaling 107DV2 Series - Manual (Page 2)

P/N 3100104 ISSUE 2
Figure 2. Detail of Bracket Mounting Figure 3. Detail of Ceiling Mounting
Maintenance Maintenance Maintenance Maintenance Maintenance
Disassemble the unit as follows (Figure 4):
1. Where applicable, remove the guard by rotating
counterclockwise.
2. Unscrew and remove the clear outer globe.
3. To replace the strobe tube, remove the inner lens and
replace the appropriate tube as listed in Table 1.
4. Reinstall the inner lens. Screw the clear outer globe
back onto the fixture housing.
5. Where applicable, install the guard assembly over the
clear outer globe by rotating clockwise until it snaps
into place.
WARNING
To reduce the risk of ignition of hazardous atmo-
spheres and shock, keep assembly tightly closed
when circuits are energized.
To reduce the risk of ignition of hazardous atmo-
spheres and shock, disconnect from the supply and
circuit and allow five (5) minutes for stored energy to
dissipate before disassembling the unit.
10 1/2"
(267mm)
11 3/8"
(289mm)
10 7/8"
(276mm)
4"
(102mm)
10 1/8"
(260mm)
9 3/4"
(248mm)
7"
(178mm)