Edwards Signaling 108-DN Series - Manual (Page 7)

P/N 3100179 ISSUE 1 PAGE 7
WARNING
To avoid electrical shock hazards, do not connect
wires when power is applied.
Pin 5 V + Red Wire
Pin 4 CAN_H White Wire
Pin 3 Drain Bare Wire
Pin 2 CAN_L Blue Wire
Pin 1 V - Black Wire
1.Make DeviceNet connections to the 5 position female terminal block plug as indicated in the below table. The 5
DeviceNet bus terminals are silkscreened near the terminals on the printed circuit board. Make connections as
follows:
Figure 1. Optional 102PMF Mounting Kit Assembly
C
(4) o-rings
A
Cat. No. 102PMF
Pipe mount flange
H
Wire retention
terminal cup washer
G
#10-16 x 3/8"
Pan head, thread forming,
ground ( ) screw
E
External tooth
#10 Star washer
F
#10-24 Hex nut
D
Mounting gasket
B
(4) #10-24 x 1" (25 mm)
pan head screws