Edwards Signaling FireShield Single-Zone Panel User Manual

Page 7

Advertising
background image

Frame these instructions and mount on the wall next to the control panel.

Operating Instruction Placard

P/N: 3100595 REV: 1.0

FireShield - Fire Alarm Single-Zone Control Panel

1 / 1

FireShield Single-Zone Fire Alarm Control Panel

Operating Instructions

PERIODIC TEST RECOMMENDATIONS

See “Preventive Maintenance,” in the FireShield Single-
Zone Panel Installation and Operating Instructions
for test
instructions and references.

Installed by

Name:

Company:

Address:

Phone:

Per NFPA 72

Protected Premises Fire Alarm System, Local

Date:

For service contact

Company:

Address:

Phone:

Acceptance Inspection by

Date:

For additional information, refer to the FireShield Single-
Zone Panel Installation and Operating Instructions
P/N 3100589.

RESPONDING TO ALARM SIGNALS
1. Evacuate the area.
2. Notify the proper authorities immediately and state

the nature and location of the emergency.

3. Be prepared to provide directions to firefighters when

they arrive.

TO SILENCE ALARM NOTIFICATION SIGNALS

WARNING! Alarm notification signals should not be
silenced until after all occupants have been evacuated.

Note: Panel programming may not allow visual notification
appliances to turn off until the panel is reset.
1. Press Signal Silence & Drill.
The Signal Silenced LED turns on and all audible
notification circuits turn off. New alarm events turn the
notification circuits back on.

TO RETURN THE SYSTEM TO NORMAL AFTER AN
ALARM EVENT
1. Make sure all smoke detectors are free from smoke

and all manual pull stations are reset.

2. Press Reset.

TO INITIATE A FIRE DRILL
1. Press Signal Silence & Drill.
All audible notification circuits turn on.

TO PERFORM A LAMP TEST

1.

Press and hold the Panel Silence and Alarm Relay
Disable buttons simultaneously.

RESPONDING TO TROUBLE SIGNALS
1. Silence the panel buzzer.
2. Investigate the cause of the trouble and notify the

authorized service personnel immediately.

TO SILENCE THE PANEL BUZZER
1. Press Panel Silence.
The buzzer turns off. Any new events turn the buzzer
back on. Trouble conditions not cleared resound the
buzzer after a predetermined time.

WARNING! Trouble conditions may affect the panel's
ability to provide early detection and indication of a fire.
Clear trouble conditions immediately.

Advertising