Fire-Lite LCD-80FC Remote Fire Indicator - Manual (Page 14)

14 LCD-80FC Instruction Manual — P/N 53244:B 5/13/2013
Mounting Semi-flush Mount Backbox
3.2.2 Mounting in Three Electrical Boxes Ganged Together
Remove the plug-in terminal blocks from the LCD-80FC circuit board. Connect the EIA-485 and
power wiring into the terminal block positions illustrated in Sections 4.1 and 4.2. Plug the terminal
blocks back into the P2 and P1 connectors on the back of the indicator. Set DIP switch SW1 for the
desired options. Refer to Figure 2.2 on page 9.
Carefully insert the LCD-80FC into the three electrical boxes ganged together and attach it using
the four mounting holes on the LCD-80FC flange and the four screws provided for this purpose.
Replace the trim ring and secure with the two screws which were previously loosened. Adjust the
plastic trim ring to the surface of the wall before tightening the screws. Do not overtighten.
Local
Silence
Lamp
Test
Hold 3 sec.
LCD-80FC flange
Three electrical boxes ganged together
flange
EIA-485 and
power wiring
L
CD8
0fcflg
.w
mf
Lc
d4
xbox.
w
mf
Three ganged electrical boxes
3g
ngb
o
x.w
m
f
mounting holes (4)
The LCD-80FC can be surface mounted in
three gangable electrical switch boxes
connected together.
Important! When installing conduit in three
ganged electrical boxes, use knockouts on the
top or bottom. Installing conduit on the sides or
back of some boxes may interfere with mounting
of the LCD-80FCin the box.
LCD-80FC
Figure 3.4 Mounting in 3 Ganged Electrical Boxes