GW Instek GLA-1000 Series User Manual - Manual (Page 77)

Data Operation
77
Data Bar Operation
Data bar shows the signal position which can be used as a place marker. Using the data bar,
you can measure relative time, frequency, and points between data.
Activate data bar
Default state
Five data bars are available by default: From left, Ds (start range) A,
T (trigger), B, and Dp (end range).
Unit
Data bar unit is selectable from address point, time, and frequency.
Press the toolbar icon to select. For unit selection details, see page65.
Address mode Time mode Frequency mode
Position
The positions of the bars are
shown on the toolbar.
Click the arrow to select the displayed bar.
Relative
distance
The distance between each bar is
also shown on the toolbar.