GW Instek GDS-200 Series User Manual - Manual (Page 150)

GDS-200 & GDS-300 Series User Manual
150
Note
Ensure the diode polarity is correct before
performing the diode measurement.
Example
Diode measurement
DMM mode Hold on/off
Continuity Measurement
Back Ground The continuity test checks that the resistance in
the DUT is low enough to be considered
continuous (of a conductive nature). The
continuity threshold level is set to <15Ω.
Connection
10A MAX
FUSED
V W COM A mA
GDS-220 Digital Storage Oscilloscope
200 MHz 1GSa/s
COM V
W
CAT II 600V
CAT III 300V FUSED
600mA MAX
Steps 1. From the multimeter settings choose the
continuity measurement.
Continuity =