GW Instek GSP-730 Quick start guide - Manual (Page 11)

USB Driver Installation
If the type B USB port on the rear panel is to be used
for remote control, then the USB driver must be
installed. The USB driver is located in the CD that
accompanied this manual.
Driver Installation:
1. Ensure the GSP-730 is turned on.
2. Connect the USB cable from the
PC to the rear panel USB B port.
3. Windows will automatically detect the GSP-730 as
a new device.
4. Follow the instructions to locate the driver on the
accompanying CD and install the driver.
5. To see if the driver has been successfully installed,
you can check to see if the GSP-730 is recognized
by the Windows Device Manager when the GSP-
730 in connected to the PC.
6. In Windows XP go to: Start>Control Panel>Device
Manager.
7. The GSP-730 should be shown under the Ports
(COM & LPT) node:
• If the USB driver installation fails, you can try to
manually install the driver by right clicking on the
AT91 USBSerial icon and selecting the Install option.