GW Instek PEL-300 - Manual (Page 17)

14
9). Setting of STEP:
n Turn the power switch to “ON” position, then press SHIFT button to enable the secondary functions.
o Press V.I.R. SET button, key in digits to specify the value of STEP, then press
↵ button to complete the
setting.
Examples:
ΠTo set STEP value at 0.02A in C.C. MODE
STEP 1. Press SHIFT
STEP 2. Press V.I.R. SET
STEP 3. Press 0.02
STEP 4. Press
↵
ΠTo set STEP value at 1V in C.V. MODE
STEP 1. Press SHIFT
STEP 2. Press V.I.R. SET
STEP 3. Press 1
STEP 4. Press
↵
Œ To set STEP value at 0.33 Ω in C.R. MODE
STEP 1. Press SHIFT
STEP 2. Press V.I.R. SET
STEP 3. Press 0.33
STEP 4. Press
↵
(10). Setting of MEMORY:
n Turn the power switch to “ON” position, then press C.C. MODE, C.V. MODE or C.R. MODE button.
o Set operational voltage, current, resistance, frequency, DUTY, time, and the times of execution.
p Press SHIFT key to enable the secondary functions; press RCL V ; key in digits to specify a batch;
then press
↵ to complete the setting and to save them in the memory.
Note: Be sure to complete the setting of the data to be saved before proceeding execution.